MDR-X feeding O-ring replacement
The official tutorial identifies the feeding O-ring as a wear part and a protective fuse when debris is drawn into the nozzle. Wear eye protection, remove magazine, disconnect battery, and clear the replica before service.
Workshop sequence
- Confirm the fault and obtain the official MDRX tool and replacement feeding O-rings.
- Follow the official footage to access the feeding assembly; keep parts organized and inspect for debris.
- Replace only the feeding O-ring, then rebuild in the shown orientation.
- Function-check safely after assembly; stop if feeding remains abnormal and consult the current exploded view.
Frames
FAQ
Why replace this O-ring?
Silverback describes it as a normal wear part and a fuse protecting mechanics after a debris incident.
Share:
Silverback MDR-X Spring swap
Silverback MDRX HPA FCU programming