News

Silverback’s official Carbon Dummy Suppressor Tutorial shows how the second-generation carbon dummy suppressor is installed as a barrel extension. This guide is useful when you need to identify the demonstrated TAC-41 setup, follow the spacer and baffle sequence, and compare the final muzzle-screw tightening pattern with the video’s key frames.

This official Silverback video demonstrates how the carbon barrel extension is assembled around the protruding inner barrel, from positioning the barrel spacer to engaging the muzzle cap. Use this guide when following the installation footage and when checking the configuration limits that Silverback publishes for SRS and TAC-41 setups.

This official Silverback video demonstrates how the SRS stock panels are removed and reassembled on the SRS-A1 / SRS-A2. Use this guide when you need to follow the panel stripdown sequence, identify the displayed hardware layout, and compare the later reassembly views with the labeled screw positions shown on screen.

This official Silverback video demonstrates how to install the dust cover on an SRS-A1 or SRS-A2. The sequence is useful when you need to follow the cover from lubrication, through placement at the open receiver slot, to its finished position on the receiver without relying on unsupported tool or torque details.

This official Silverback video demonstrates how to adjust the trigger preload setting on an SRS-A1 / SRS-A2 when piston sear engagement feels too hard. Use this guide to follow the video’s five fixed checkpoints, from the initial BB warning and 1.5 mm hex-tool reference through action testing, preload reduction and the final safety warning.

This official Silverback video demonstrates how the SRS Sport polymer magazine is opened, stripped down and reassembled. Use this guide when you need to follow the video’s visual sequence: first releasing the magazine, then handling the spring, BB stopper and follower components, and finally using the specified rigid rod as the magazine is closed.

This official Silverback video demonstrates how the monopod is fitted to an SRS stock after the stock panels have been removed. Use this guide when you need to follow the short installation sequence visually, from the exposed stock mounting position through insertion, upright positioning and tightening with the specified 20 mm wrench.

This official Silverback video demonstrates the SRS-A2 handguard swap from the initial tool callout through removal, replacement, and fastener reinstallation. Use this guide when you need to follow the visual sequence for changing the handguard, while keeping the source-defined torque limits for polymer and metal handguards in view.

The official Silverback video demonstrates how to adjust cheekpad height on the SRS-A1 and SRS-A2. This guide is useful when you need to follow the brief adjustment sequence: identify the specified hex key, loosen the cheek-pad fasteners, reposition the pad, and tighten it at the selected height.