Drop-in Prowler Hop Plate for MK23/SSX23 Socom

CNC machined Aluminium upgrade to improve range and accuracy as well as replace stock hop arm in the airsoft TM/STTi/ASG Mk23 and SSX-23.

Made with high tolerance and engraved with the STALKER logo this Mk23 Prowler plate offers you an awful lot of advantage when it comes to simplifying the hop-up assembly. All wobbly parts are a thing of the past, an arm can sometimes go skewed because the wheel of your stock Mk23 pulls the arm down on 1 side. With this plate, you ensure that your hop-up plate plus nub is always forced straight down TDC. in combination with the STALKER TDC hood you make sure that the screw of the hood lands right on the center position of the prowler plate and this gives you the best hop-pup effect.

The nub shape of this plate is the same as the Prowler nub shape we used on our Kraken SRS Purple Nubs. it has the same shape as most used buckings and after all, proven to work with amazing results in the SRS Kraken.

***Installation Steps***

1. Open hop-up
2. Remove hop wheel and stock hop arm and screws.
3. Install chosen barrel and bucking.
4. Close the Hop assembly.
5. Install the STALKER Prowler Hop Plate for Mk23 into the hop-up
6. Fit the STALKER TDC HOOD onto the hop unit.
7. Rebuild your MK23.
8. Test shoot and adjust the hop-up from the top with the grub screw of the STALKER TDC Hood.

• Fits TM MK23 Hopup
• Fits Novritsch SSX-23 Hopup
• Fits Stti MK23 Hopup
• Fits ASG MK23 Hopup
• Lifts heavy Weight BB's
• Might work with other TDC Covers