Official video workshop · 1:53
MDR-X Barrel removal
Remove the barrel assembly for barrel, nub, hop-rubber or inner-barrel service.
Before you start
Safety, tools and revision
Safety. Disconnect the battery, wear eye protection and unload the replica. Follow local law; chronograph after any change that can affect energy.
Revision. Legacy MDR-X V1/V2 video. V3 documents show separate 16-inch and Micron barrel/hop assemblies; identify the V3 assembly before work.
Tools
- Eye protection
- Appropriate hand tools
- Chronograph where applicable
Primary source
Official Silverback tutorial
Procedure frames
Procedure
Step by step
1
Remove the handguard
Follow the orientation in the official frame and video; do not force components.
2
Loosen barrel clamping screws
Follow the orientation in the official frame and video; do not force components.
3
Withdraw the barrel assembly straight out
Follow the orientation in the official frame and video; do not force components.
4
Reinstall within stated torque limits
Before use, complete a safe function check and chronograph with the BB used.
Critical checks
- Battery disconnected and eye protection worn.
- No forced parts; official torque limits respected.
- Safe function check, chronograph and local compliance.
FAQ
Frequently asked questions
What torque limits apply?
Maximum 3 Nm for barrel clamping screws and 2 Nm for handguard screws.
Does it apply directly to V3?
Do not assume so: confirm V3 documentation and references before disassembly.
Share:
Silverback MDR-X Trigger PCB swap
Silverback MDR-X Hop rubber and inner barrel swap