News
Silverback MDR-X High nub swap
Replace the installed low nub with the supplied high nub for heavy-BB tuning.
Silverback MDR-X Hop rubber and inner barrel swap
Swap the AEG-type flat hop rubber and/or inner barrel after barrel removal.
Read moreabout Silverback MDR-X Hop rubber and inner barrel swap
Silverback MDR-X Barrel removal
Remove the barrel assembly for barrel, nub, hop-rubber or inner-barrel service.
Silverback MDR-X Trigger PCB swap
Replace the trigger PCB for the official Semi/Full or Semi-only configuration.
Silverback MDR-X Magazine stripdown
Disassemble and rebuild the official MDRX 78-round magazine without damaging the base tab.
Install the battery and set the control-board jumper for the battery condition shown by Silverback.
A visual introduction to the MDR-X platform. This is not a maintenance or operating procedure: the official video contains no spoken fitting, firing, or adjustment instructions.
Silverback VKS Quick Strip-Down and Reassembly Guide
Field-strip and rebuild the Silverback VKS: spring-guide safety, 5 mm barrel removal, 6 mm lock pin, 4 Nm clamps and correct pin order.
Read moreabout Silverback VKS Quick Strip-Down and Reassembly Guide
Silverback VKS Fixed Dust Cover Setup Guide
Configure the Silverback VKS ejection-port cover to stay closed: notch orientation, bolt-linkage engagement, pin order and final check.