News

This official Silverback video demonstrates the installation of an advanced piston head on the SRS / TAC-41 platform, including removal of the original head, heat-assisted loosening, tightening with a 6 mm pin and 12 mm flat wrench, and later airbrake adjustment. Use this guide when you need to follow the video’s visual sequence or confirm which piston-head version matches the cylinder-head and hop-up arrangement.

This official Silverback workshop video follows the TAC-41 P from individual components through its completed assembly. It is useful when you need a visual overview of the full sequence, from the piston and bolt through the receiver, stock, magazine and final function check, while keeping adjustment-specific work separate in the dedicated tutorials linked by Silverback.

This official Silverback video demonstrates how the TAC-41 trigger’s preload and travel adjustments change the trigger setup. Use this guide when following the video’s adjustment sequence and comparing the empty feeding ramp, disengaged magazine, adjustment tool, and trigger feel at each checkpoint.

This official Silverback video demonstrates how to swap the hopup rubber in a TAC-41 using an AEG type original hopup. The guide is useful when reviewing the complete visual sequence, from the marked rubber and inner barrel through hop-up disassembly and the final alignment of the chamber, outer barrel and adjustment wheel.

This official Silverback video demonstrates how the TAC-41 P polymer stock is adjusted for stock ergonomics, from the cheek-rest knob to the buttplate and spacer arrangement. Use this guide when you need to follow the video’s visual sequence or confirm which spacer range and screw detail apply to the standard configuration and the additional kit.

Silverback’s official TAC-41 - Spring Swap video shows the spring-change sequence from opening the cylinder assembly to fitting the replacement spring and closing everything again. This guide is useful when you need to follow the same visual checkpoints, compare the spring-guide stopper’s orientation, and keep the official compatibility limitation in view before selecting a spring.

Silverback’s official TAC-41 - Barrel Swap video demonstrates the complete outer-barrel change from the original 510 mm tapered barrel to the optional 330 mm fluted CNC barrel. This guide is useful when you need to follow the video’s checkpoint sequence: loosen the stock screws from muzzle toward bolt, remove the original barrel, reverse the operation with the replacement, and finish by tightening at 4 Nm.

This official Silverback video demonstrates the disassembly and reassembly of the TAC-41 short magazine, identified as T41-1000. It is useful when you need to follow the magazine’s internal parts from the careful opening stage through removal, layout and reverse-order rebuilding, including the 4 mm rigid pin shown guiding the spring during reassembly.

This official Silverback video demonstrates how a TAC-41 is converted between right-handed and left-handed operation. Use this guide when following the video and comparing the bolt, locating pin, fasteners, receiver, and stock-side pieces at each visual checkpoint, especially when the TAC-41 has a steel bolt assembly or is a Sport model.